Craftsman Air 919-167342 Compressor Manual

The Craftsman Air 919-167342 is a reliable air compressor designed for various tasks including inflating tires, powering pneumatic tools, and more. This manual provides essential information on safety, features, installation, operation, and troubleshooting to ensure optimal performance and longevity of your compressor.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Troubleshooting

Features at a Glance

Key components: Oil-free pump, 6-gallon tank, 150 PSI maximum pressure, quick connect coupler, and built-in pressure gauge.

Feature	Description
Oil-free pump	Requires no maintenance and provides clean air.
6-gallon tank	Provides ample air storage for various applications.
150 PSI maximum pressure	Delivers high pressure for efficient tool operation.
Quick connect coupler	Allows for easy attachment of air hoses and tools.
Built-in pressure gauge	Monitors air pressure for optimal performance.

Installation

Unpack the compressor and inspect for any damage. Place the unit on a stable surface away from moisture.

Connect the air hose: Ensure the compressor is off before connecting.
Plug into a grounded outlet: Use a dedicated circuit to avoid overload.
Check oil levels: Ensure the oil level is adequate if applicable.
Turn on the compressor: Allow it to build pressure before use.

WARNING! Always follow safety precautions to avoid injury.

First-Time Setup

Before using the compressor, ensure all connections are secure and the unit is properly set up.

Check for leaks: Inspect all connections for air leaks.
Set the pressure: Adjust the regulator to the desired pressure for your tools.
Test operation: Run the compressor briefly to ensure it operates correctly.

CAUTION! Do not exceed the maximum pressure rating.

Specifications

Model: Craftsman Air 919-167342.
Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Power Source: 120V AC.
Weight: Approximately 40 lbs.
Dimensions: 24 x 18 x 18 inches.
Noise Level: 68 dBA.

Controls and Settings

The compressor features a simple control panel with an on/off switch, pressure regulator, and pressure gauge for easy operation.

Pressure Regulator: Adjusts the output pressure to match your tool requirements.

On/Off Switch: Powers the compressor on and off.

Connecting Devices

To connect devices, ensure the compressor is off and follow these steps:

Attach the air hose to the quick connect coupler.
Connect your pneumatic tool to the other end of the air hose.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting.

Operating the Compressor

To operate the compressor, follow these steps:

Turn on the compressor using the on/off switch.
Allow the compressor to build pressure to the set level.
Use your pneumatic tool as needed.
Turn off the compressor when finished.

WARNING! Do not operate the compressor in wet conditions.

Maintenance

Regular maintenance is essential for optimal performance:

Check and replace air filters as needed.
Drain the tank regularly to prevent moisture buildup.
Inspect hoses and connections for wear and tear.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check power cord and outlet.
No air pressure	Leak in the system	Inspect for leaks and tighten connections.
Excessive noise	Loose parts	Tighten any loose screws or components.
Pressure not building	Faulty pressure switch	Replace the pressure switch if necessary.

Service: For further assistance, contact customer support.